Picture Framing for Photographers - Part 2

Home
>
Photography
>
Picture Framing for Photographers - Part 2

Picture Framing for Photographers - Part 2

There are two sources for obtaining the moulding for making a frame. You can firstly start with a straight piece of timber, and using a home routing system make your own moulding shape with a rebate to take the art work. Alternatively you can pick from a large range of ready finished mouldings available from your local frame shop or hardware store. I recommend the latter. It's easier, the choice is much wider, and it's more cost effective. However, one word of warning. Always look for a moulding with a good straight back and not too flat on the surface. If the moulding has a bump or some raised section in the top surface it will cut and join easier than a flat moulding. Most mouldings are made from pine or obeche. These are soft grain timbers and cut and join well. Hard timbers like ramin are more difficult to work with.

Measuring and Cutting

How much moulding will you need? The outside dimensions of the frame are determined by the size of the mounted photograph. Carefully measure the overall size of the matted picture you're framing, adding a little extra (3-smm) for "play" to ensure the picture fits easily into the finished frame.

Add the length and the breadth together, then double the total. This will give you the overall length. But you also have to allow for the mitre cuts, so multiply the width of the moulding by 10 and add this to your total (total length required = 2 x (length + breadth) + 10 x width of moulding). The 45 mitre cuts are most important - a bad cut will never join properly and will always look terrible. There are a number of machines on the market for cutting 45 degree mitres starting with the simple mitre box, radial arm saw with a mitre attachment, or a commercial mitre saw (see picture 1).

Cutting one side of a frame is easy. Cutting the second side to be EXACTLY the same side to the first side is the hard part of frame cutting. Using a measuring system you can cut lengths accurately every time. The FrameCo measuring system will attach to any brand of electric or manual mitre saw and will make the cutting of the frames quick and foolproof.

If you have a saw you can cut without using a measuring system. Follow this easy step-by-step guide to cut mitred lengths for your frame:

* Calculate the dimensions of your frame.

* Place the moulding into the saw.

? Cut off a small piece at 45 degrees with the saw in the lefthand position.

* Remove the moulding from the saw.

? With a tape, measure along the back of the moulding, to the length you require.

To this length you have to take into account the size of the moulding you are using. So you add to the length of the side an amount equal to twice the moulding width - not including the rebate. Then make a pencil mark on the back of the moulding near the top so that you can see the mark.

? Put the moulding back in the saw and align the saw blade on the pencil mark.

? Swing the saw around and cut the next mitre.

? Place the two pieces back to back so you can transfer the size you have just cut to the back of the moulding length.

? Repeat the cutting procedure for the other pieces.

Joining the Frame

To ensure a tight and stable joint, glue should be applied, especially if the frame is large. A light smear of a good quality PVA glue is all that's necessary. Although it is possible to buy clamps that join two corners at a time, it's simpler and quicker to clamp all four corners at once. This allows you to see how the corners match up before gluing and securing the mitres. There are several types of clamps...

Cord Clamps: This simple, but effective clamping system works well for small to medium-size frames. It consists of four flexible plastic corners and a length of cord. (See picture 2).

Metal Strap Clamp: This clamping system is slightly more sophisticated and consists of a metal strap, flexible corner pieces and a screw operated tensioning device which allows you to apply a considerable amount of tension so that the corners are pulled together tightly. The Strap Clamp is suitable for large and small frames. (See picture 3).

Once the frame is clamped together and you've made sure all the corners are aligned, then the mitre joint should be secured or reinforced. Glue alone is not safe and secure enough for most sized frames. Here are some options.

Panel Pins: You can nail a panel pin across the mitre. It is advisable to pre-drill the holes and secure the joint in a vice before hammering the pins into the frame. Punch home the nail head and fill the hole with a coloured woodfiller.

V-Nails: Professional framers use these v-shaped staples, which are inserted using a special manual or pneumatic joining machine. The "PushMaster" is a DIY version of these machines and is suitable for low-volume high-quality framing such as required for photography or portrait framing.

Biscuit Joints: More suitable for large and heavy frames such as mirrors. Most commercial picture frame mouldings are small and a biscuit joint is not necessary.

V-Nail Joining Machines There are several models of these machines and all are suitable for the DIY or low-volume picture framing. Here are some of the models.

PushMaster: Similar to a large punch, the PushMaster is a handheld, easy to use tool for inserting the v-nails into the back of timber picture frames. The vnail is loaded onto the magnetic end of the PushMaster, sharp end down, then simply pushed into the wood. The v-nail pulls the joint together because it is made from spring steel. The advantage of the PushMaster is that it doubles as a fitting up tool. The magnetic tip can also be used to fit flexipoints and backing nails to secure the picture into the frame. (See picture 4).

BenchMaster: The BenchMaster is ideal for the serious DIY framing photographer. The powerful cam action of the handle combined with the heavy duty Push Master drives v-nails into the hardest of timbers. Its gentle hand action suits joining small or odd-shaped mouldings. If you start with FrameCo's Push Master you can upgrade to the BenchMaster at any time. (See picture 5).

V-Nails - How Do They Work?

Upon entering the wood moulding from the base, the sides of the metal v-nail are deflected outwards. As the v-nail pulls back into its original shape this pulls the joint tightly together. There is a little curl on the outer leading edge of the nail that locks the nail into the grain of the timber. This stops the nail from pulling out of the end of the mitre, keeping the joint stable and secure. The v-nail method of joining is the preferred method of professional picture framers. With a few simple hand tools it's possible to achieve the same result with a minimal outlay in machinery.

Making Multi-sided Frames

With most good quality suspension type mitre saws there's always the possibility of cutting mitre angles other than 45 degrees. The problem is that the saws do not have a system of measuring the length of the cut. The FrameCo measuring system has a clever scale included with the unit. It allows you to measure a length for any angle. A six-sided frame has the six mitres cut at 30 degrees, while an eight-sided frame has the eight mitres cut at 22.5 degrees. The Measure Mate Scale converts the measuring system into a multi-angled scale so that each one of these different angled mitres can be measured.

So it's possible for the amateur framer to make attractive multiangled frames that add style and creativity to your framing.

Finishing and Assembly

Now that the frame is joined and the glue joints dry you're ready to assemble your mounted photograph into the frame. The PushMaster can be used to fit backing nails or flexipoints into the frame to hold the picture into the rebate.

Seal the back of the picture with gummed tape or good quality backing tape. The best backing tape to use is a silicone coated tape as this will not peel off over time.

Screw two small O-rings or screw eyes into the side of the frame, approximately one third of the distance down the top of the frame, then attach a length of wire or cord securely through the O-rings or screw eyes. After that, your image is ready to hang on a wall.

Gary Leete, of Frameco Picture Framing Supplies, is a professional framer. For further information on any of the his DIY picture framing tools contact FrameCo P/L Australia, Ph: (03) 98723600 or visit the web site at http://www.clubframeco.com

In The News:

Yahoo! News: Top Stories

Obama announces Clinton, Gates for Cabinet (AP)

AP - President-elect Barack Obama picked a national security team headed by former campaign rival Hillary Rodham Clinton and Bush administration holdover Robert Gates on Monday, and said he wants to consult with military commanders before settling on a firm timetable to withdraw U.S. combat troops from Iraq.

It's official: US is in recession (AP)

AP - The U.S. economy has been in a recession since December 2007, the National Bureau of Economic Research said Monday.

Obama still looks for Iraq pullout in 16 months (AP)

AP - Barack Obama says the U.S.-Iraq security agreement approved by Iraq's parliament puts the U.S. on a "glide path" toward reducing forces there.

Pelosi hopes for stimulus bill by Inauguration Day (AP)

AP - House Speaker Nancy Pelosi is promising Congress will try to have a huge economic recovery bill ready for President-elect Barack Obama as soon as he takes office.

Police respond to shooting at Miami mall; 2 hurt (AP)

AP - Authorities responding to a shooting at suburban Miami mall say one person has been shot and taken to a hospital.

Holiday shopping season off to a modest start (AP)

AP - The Thanksgiving shopping weekend may not have been the disaster some had feared, but unprecedented discounts and tempered buying likely resulted in overall soft sales as a buying binge on Friday quickly fizzled. Now, online retailers are ramping up deals to turn skittish shoppers into "Cyber Monday" spenders.

India demands 'strong action' from Pakistan (AP)

AP - India demanded Pakistan take "strong action" against those behind the 60-hour siege that left at least 172 people dead, as new details emerged Monday about the gunmen and the survival training that enabled them to thwart Indian commandos.

Sending spam in Israel could mean a big fine (AP)

AP - Israel has gotten fed up with spam. Anyone who sends out messages without receiving the recipient's consent can now be slapped with a big fine.

Tina Fey's husband talks about her facial scar (AP)

AP - Tina Fey's husband is talking about something the "30 Rock" actress would rather not discuss: the scar on her left cheek.

Police investigating hospital in Burress shooting (AP)

AP - Authorities investigating Plaxico Burress' accidental shooting say they are looking into what roles his teammate Antonio Pierce and the hospital that treated Burress played in the incident.

Obama names Clinton, Gates to lead foreign policy (Reuters)

Reuters - U.S. President-elect Barack Obama named former rival Hillary Clinton as secretary of state on Monday and said Robert Gates would remain defense secretary in a national security team charged with recasting America's leadership role in the world.

Economic slump and spending woe sink Wall Street (Reuters)

Reuters - Stocks slid on Monday as news pointing to the deepening economic slump around the world punctured last week's market enthusiasm, with financial services companies and retailers among Wall Street's biggest casualties.

India demands swift Pakistan action over Mumbai (Reuters)

Reuters - India on Monday demanded Pakistan take swift action over deadly attacks in Mumbai it said were carried out by militants from its rival neighbor.

Thai protesters consolidate hold on airport (Reuters)

Reuters - Thai protesters prepared to end their three-month occupation of the Prime Minister's office on Monday to consolidate their grip on the main airport ahead of a court verdict that could dissolve the elected government.

Europe mulls spending hikes as world factories slow (Reuters)

Reuters - European leaders clashed on Monday over how much public money to spend on battling recession as data showed factories were slashing output in the United States, Europe and China.

Pelosi seeks fast action on stimulus bill (Reuters)

Reuters - House of Representatives Speaker Nancy Pelosi met leading governors on Monday to discuss the size and shape of an economic stimulus package she hopes Barack Obama can sign when he becomes president on January 20.

Alabama mayor arrested on corruption charges (Reuters)

Reuters - Federal authorities arrested the mayor of Birmingham, Alabama, on Monday in a corruption probe surrounding a massive sewer bond debt that has forced Jefferson County to the brink of bankruptcy.

Retail stocks fall on holiday shopping worries (Reuters)

Reuters - Key retail stocks fell on Monday as investors feared that deep discounts offered by U.S. stores during the year's first holiday shopping weekend could sap profits and would not save a bleak season.

Hawkish Obama names Clinton as top diplomat (AFP)

AFP - Barack Obama on Monday nominated Hillary Clinton to be his "tough," "smart" secretary of state and his former foe vowed to give her all to steer America through a perfect storm of global crises.

Mumbai attacks: India demands Pakistan take 'strong action' (AFP)

AFP - India on Monday formally accused "elements" in Pakistan of being behind the devastating Islamic militant attacks in Mumbai and demanded that Islamabad take "strong action".

Picture Framing for Photographers - Part 2

Photography Photography